76 Photos
208 Photos
136 Photos
The Mustang is on the road. We installed a mustang 2 front suspension with tubular a-arms and coilovers. We jammed a 460 in between the frame rails with a Tremec transmission to handle the power. We also handled all the metal, body, paint, and assembly work.
25 Photos
72 Photos
29 Photos
The Corvette is complete. We repaired the drivers side front fender, smoothed the front bumper into the body, and then did the same to the rear bumper.
7 Photos
34 Photos
37 Photos
We completed all the metalwork on the Torino. We replaced all the floor pans, rad. support, battery apron, lower rear quaters on both sides, repaired the cowl which was in very bad shape, and the lower outer wheelhouses.. We also installed a Mustang II front suspension, and removed the shock towers.
83 Photos
13 Photos
The GMC recieved a custom power steering setup. We repaired the exhaust and install rubber isolators to take away the interior vibration, as well as installed Dynamat and a new firewall insulator.
16 Photos
The Corona had a short list of needed repairs. We recovered the passenger seat, dyed the headliner, and installed an original factory resonator.
10 Photos
The Thunderbird needed a few things to get it on the road and through inspection. We repaired the front passenger floor pan, battery tray, recovered the drivers seat, and installed new door panels.
10 Photos
45 Photos
19 Photos
69 Photos
We have completed our work on the Wrangler. The wrangler came to us in as a 4 cylinder the had been sitting for a while and needed some serious attention. We repaired driver and passenger body tub corners as well as the drivers side pass floor. We sprayed the Wrangler a flat charcoal, added upgraded front and rear bumpers, 35" tires, a hardtop, installed a 4.0 with an AX-15 trans and a NP-231 transfer case with a slip yoke eliminator. We also installed a BDS Suspension 4.5" lift with swaybar disconnects. We fit the interior with Dynamat, a new Kenwood Stereo and speakers, and new carpet all around. We also took care of all the safety items before the Jeep left the shop.
8 Photos
The power wagon got a quick detail. We also rewired some dash components while it was here.
5 Photos
We will be assembling Fibersteel's front luggage compartment aluminum pieces. Painting the underside of the clamshell as well as the hood, and relocating the battery.
32 Photos
The coupe has a long list of modifications. We installed hidden hinges, bear claw latches, grafted a '96 dodge ram hood into the roof, smoothed the cowl, chopped the roof 3 inches, hand fabricated rear body to frame rails, installed a new firewall, new deck lid gutters, and floor pans.
24 Photos
We will be replacing the entire floor, as well as the trunk floor. The camaro will also get a set of new inner and outer rockers.
31 Photos
58 Photos
14 Photos
23 Photos
The metalwork on the '71 Camaro is now complete. We replaced the firewall, front floor pans, outer rockers, outer wheelhouses, full quarter panels, tailpanel, and trunk floor drop-offs.
11 Photos